Delivering unparalleled down hole RPM to the bit, heat poof, compatible with harsh environments.

Mostly impregnated diamond bits, Hybrid bits, PDC bits (30%) large size, PDC (95%) Slim bits

Directional Drilling (Steerable Turbine, all sizes), Staight turbine for performance drilling, in Over or UnderBalanced drilling conditions

Pumped fluids which can be liquid (Water, Oil Base Mud, Synthetic Mud) or mix of Fluid with Gas (commonly Nitrogen) with a minimum of 20% of liquid.

Turbine is demanding on hydraulic power (high differential pressure), commonly 2000 psi which can be a limitation if the rig is not sized enough or other pressure losses can’t be limited.

No damage occurs during a stall (unlike PDM) and therefore there is no need to back off the flow while sliding.

No, on countrary, the level of vibration is very low alowing a clear transmission of MWD signal.

Reliably 600+ hours, depending on mud weight, operating parameters.

Blades of rotor and stator transforming the hydraulics power in mechanical power (combination of RPM and Torque), Thrust Bearing bearing the hydraulics thrust, Radial Bearing supporting the radial forces. Impoving the efficiency and durability of these key elements remain a constant focus of our R&D project.

Straight or adjustable Bent housing, OD of Lower & mid-body stabilizers, Power (qty of stage of blades) – number of hydraulics thrust bearing stages to be adjusted in accordance.

Turbine are usually charged per circulating hours below rotary table (BRT) or on performance with a cost per meter of foot, in additional come a daily stand-by + maintenance charge and supervision charge on rig site.

«Turbodrill / PDM» ~ «Jet boat / propeller boat».